# A build with a feminine touch?

**URL:** https://foil.zone/t/a-build-with-a-feminine-touch/11740
**Category:** Builds
**Created:** [February 2, 2021, 12:58am UTC](https://foil.zone/t/a-build-with-a-feminine-touch/11740 "2021-02-02T00:58:15Z")
**Posts on this page:** 1
**Showing post:** 2

<div class="post-metadata">

### Author: ![3rd\_ave\_Lien](https://foil.zone/user_avatar/foil.zone/3rd_ave_lien/32/17688_2.png) [@3rd\_ave\_Lien](https://foil.zone/u/3rd_ave_Lien)
#### Post date: [February 2, 2021, 1:15am UTC](https://foil.zone/t/a-build-with-a-feminine-touch/11740/2 "2021-02-02T01:15:48Z")

</div>

To get started, I printed the motor mast clamp, just because it seemed like something I could do.  
Following the [method used by YAHEF](https://foil.zone/t/yahef-from-norway/5682), I adapted the design to my mast and motor using fusion 360, and to make a long story short, ended up printing it in PETG with 100% fill.

**QUESTION:** has anybody used a PETG mast clamp without any additional processing (fiberglassing, epoxy filling, etc…)? I just reinforced mine with a couple of heavy duty (200lb) tie wraps around the circumference…

**EDIT** : after reading [here](https://www.youtube.com/watch?v=fbSQvJJjw2Q) about improving the strength of the print, i might reprint the clamp with:

- PETG
- layer height: 0.15mm
- layer width: 0.56 mm (140% of nozzle width)
- perimeters, top and base layers: 10
- infill: 100% honeycomb (don’t know if patterns matters at that point)

Not taking any chances!

 ![Screen Shot 2021-02-01 at 5.11.45 PM](https://foil.zone/uploads/default/original/3X/2/5/259457aa2c285b73bb0319f4082fcc0b18107151.jpeg)

---

_[View the full topic](https://foil.zone/t/a-build-with-a-feminine-touch/11740)._