Hi,
I’m building my Bremote v2 with GPS. I initially got a kit from Jasmin that used the BN-220 gps module. I can see things have moved on a bit and the m100 mini is preferred so I’ve bought that and I’m ready to solder the 4 cables from the m100 mini to the tx board. In Ludwigs video he has the BN-220 soldered to the GND, g19, g18 and the 3.3v pins. The m100 mini comes with cables pre-soldered to the GND, 5v, tx and rx pins on the m100. Which pins do these connect to on the Bremote tx? I can see the Bremote tx has a tx and rx pin as well as a g19 and g18. Also, is 5v connected to the 3.3v ok? Any guidance is much appreciated given I’ve only got one shot at this before potting it.
Thanks