# Hall effect remote

**URL:** https://foil.zone/t/hall-effect-remote/3184
**Category:** Electronics (ESC, remote, batteries)
**Created:** [October 26, 2018, 8:20pm UTC](https://foil.zone/t/hall-effect-remote/3184 "2018-10-26T20:20:15Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![Dandydan](https://foil.zone/letter_avatar_proxy/v4/letter/d/a9a28c/32.png) [@Dandydan](https://foil.zone/u/Dandydan)
#### Post date: [October 26, 2018, 8:20pm UTC](https://foil.zone/t/hall-effect-remote/3184/1 "2018-10-26T20:20:15Z")

</div>

Hey guys I’m making a remote with a Hall effect sensor but I can’t find anywhere how to wire it in place of the potentiometer. Thanks in advance.

---

<div class="post-metadata">

### Author: ![Benjo](https://foil.zone/user_avatar/foil.zone/benjo/32/3424_2.png) [@Benjo](https://foil.zone/u/Benjo)
#### Post date: [October 26, 2018, 9:02pm UTC](https://foil.zone/t/hall-effect-remote/3184/2 "2018-10-26T21:02:44Z")

</div>

You can find loads of diagrams and tutorials on the internet, but best is to look into the datasheet of your specific sensor.

Most of the time - if you look at the side with the rounded edges - you have VCC on the left pin, then GND in the middle and the signal pin on the right.  
Also find out the required supply voltage.