# JDubs Dual Motor Tow Boogie

**URL:** https://foil.zone/t/jdubs-dual-motor-tow-boogie/19048
**Category:** Builds
**Created:** [September 8, 2023, 12:40am UTC](https://foil.zone/t/jdubs-dual-motor-tow-boogie/19048 "2023-09-08T00:40:47Z")
**Posts on this page:** 1
**Showing post:** 109

<div class="post-metadata">

### Author: ![thuffam](https://foil.zone/letter_avatar_proxy/v4/letter/t/cdc98d/32.png) [@thuffam](https://foil.zone/u/thuffam)
#### Post date: [March 21, 2024, 10:34pm UTC](https://foil.zone/t/jdubs-dual-motor-tow-boogie/19048/109 "2024-03-21T22:34:40Z")

</div>

Regarding printers… just an FYI to those with a budget printer… I’m using an Ender 3 V2 and getting superb results on PLA, PETG and PETG-CF - up to about 0.2 layer height- my preference is 0.15 as it give more strength, better finish and a good balance on speed vs quality. Yes they are much slower than Bambulabs printers but still capable. Check my [build topic](https://foil.zone/t/topic/20299/1) (2nd or 3rd post) where I document settings.

---

_[View the full topic](https://foil.zone/t/jdubs-dual-motor-tow-boogie/19048)._