# Looking for an STL / 3D model: Motor Pod / Mount for Sabfoil Mast (DIY Foil Assist)
**URL:** https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984
**Category:** Build, Repair & Mod
**Created:** [August 10, 2026, 7:26am UTC](https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984 "2026-08-10T07:26:03Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@Gil](https://foil.zone/u/Gil)
#### Post date: [August 10, 2026, 7:26am UTC](https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984/1 "2026-08-10T07:26:03Z")
**Hey everyone,**
**I’m working on a DIY Foil Assist project and I’m currently looking for a 3D printable STL file for a Motor Pod / Mount tailored specifically for:**
\*\*\* **Mast:** Sabfoil Carbon Mast 91\*\*
\*\*\* **Motor:** Flipsky 6384\*\*
**I’ve been searching through Printables, Thingiverse, and foil forums, but most mounts I find are for Gong, Axis, or generic dimensions. Since the Sabfoil carbon mast has a very specific profile, I want to make sure the pod fits snugly without damaging the carbon.**
**Does anyone happen to have, or know where I can find, an STL or CAD model adapted for this exact setup?**
**Any help or links would be hugely appreciated!**
**Thanks in advance!**
---
### Author:  [@volkv](https://foil.zone/u/volkv)
#### Post date: [August 11, 2026, 1:02am UTC](https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984/2 "2026-08-11T01:02:57Z")
If you have a mast profile (doesnt have to be a spline, just thickness at 0mm 5mm 10mm and up to 70mm in 10mm increments) I can create you an STL. Also, there are different pod designs, single tpu strap, single zip, two zip ties, separate motor mount with dovetail into the cone, etc…
---
### Author:  [@Gil](https://foil.zone/u/Gil)
#### Post date: [August 11, 2026, 7:32am UTC](https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984/3 "2026-08-11T07:32:56Z")
THX Volkv
its 11.60CM
on 1.4CM
2 or 3 zipties will be perfcet
---
### Author:  [@volkv](https://foil.zone/u/volkv)
#### Post date: [August 12, 2026, 5:09pm UTC](https://foil.zone/t/looking-for-an-stl-3d-model-motor-pod-mount-for-sabfoil-mast-diy-foil-assist/26984/4 "2026-08-12T17:09:51Z")
Need something like this below:
