Fliteboard prop for Flipsky 65161

Build, Repair & Mod
61

Curious about why you made the pin retention slots in both directions?

62

Because it’s just a notch easier to assemble, as it snuggs in faster.

63

Curious if you have experience with both the printed and the actual. I am about to buy the actual one but wouldn’t mind printing if I can. Don’t even have my board yet but if you were able to get good results with the printed one I might hold off on ordering and give printed one a shot.

64

Hi, Did you ever mange to find a prop guard for the flite prop and 65161 motor? Thanks

65

I did. Wouldn’t recommend it though. I never could get it to “foil”. It was cavitating pretty bad.