Hi All, I’m new to the forum, and starting to build my first efoil!
I have been sourcing parts (thank you, these forums are pretty special) and think I found a very cheap remote not mentioned on the forums.
Its made by someone called Mayitr and claims to be IP67 water resistant - and only cost me £25 ($32)!
Comes with receiver and wireless charge pad.
I’m sure its no where near as good as the posh Maytech one,but at one 10th of the price its probably a good starting point!
I’ve ordered one as I was planning on buying a cheap £17 radio / receiver set for testing anyway, so I’ll let you know what its like
we have already talked about this remote control. Unfortunately, this is not waterproof but you can still use it in the rubber glove. There are also instructions to build this that you Waterproof.
If you take it apart, give it an extra coating of plasti-dip and then drill a good drainage hole in the casing. Then it should be alright for a while. plasti-dip and the fill the inside with some expanding foam and see if that helps.
Ok i was doing it right, after putting back in place and reassembling it, put some throttle and it the spring jump out…
The spring is not well maintened inside the remote
this remote is seriously dangerous, i can see the board flying away with a blocked throttle.
I will try to modify it