Need some help on motor config and app config for Flypsky 65161 motor with FSESC75200 75V

EFOIL.builders Builds

superlefax March 6, 2021, 8:35pm 4

Check the following:

VESC6 + 80100 troubleshooting Electronics (ESC, remote, batteries)

Hi folks, I’m quite desperate running my new 80100 motor with the trampa VESC6+ controller. The default vesc6 firmware is limited by software to a max motor current of 120A. Unfortunately that is not enough to get on plane for me (80kg, RL-wing, good working propeller, 80l board volume). That’s why I needed to flash the VESC with the no hw limits firmware to adjust the motor current to a higher value than 120A. I’m now facing the problem that exactly above 100A the motors begins to get out of…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled