New Direct Drive Inrunner 65150

Flying_Rodeo · October 27, 2019, 8:51am

Yes it’s 6 inch …

Guys FLY fast and stay HIGH

carved · October 27, 2019, 10:27pm

Hey guys all of you using the maytech/flipsky/reacher motor. Can you please dismantle it after 10hours usage? I already have abrasion on the shaft! where the is located and slow water penetration… Want to know if its just on mine or on all of them…

Jezza · October 28, 2019, 7:52am

That’s interesting. Thanks for letting us know.
Has the inside been treated at all?
They may have used the wrong seals.

Onhill · October 28, 2019, 3:06pm

hy jezza where did you get the mast mount i need the same for my reachertech motor

Jezza · October 28, 2019, 4:55pm

Flying Rodeo…

Ackermann · October 28, 2019, 6:59pm

I printed with 0% infill and filled with epoxy. Feels Rock solid. OP for clamp is

michion · October 28, 2019, 10:43pm

Got any photos? …

MAC · October 29, 2019, 10:47pm

Please show photos of the damaged area.

Manufoil · October 29, 2019, 10:51pm

No marks at all after 6hours

carved · October 30, 2019, 4:06pm

see the picture of the shaft…
Would be great if someone with 20hours and 40hrs. could detach his motor as well and inspect it

Jezza · October 30, 2019, 4:18pm

Has it reduced in diameter or is it just scuffing?

millesth · October 30, 2019, 5:27pm

Have you been able to reassemble it properly afterward ?

Jezza · October 30, 2019, 5:30pm

Another question, can the shaft be easily replaced?

VeFoil · October 31, 2019, 12:19am

Have you tried cutting the shaft for this motor to see how hard it really is? I found some of the motor shafts drill and cut like butter while other quality shafts from like TPPower and SSS were rock solid and I had to take them to machine shop.

What motor are you using Maytech, Flipsky, or Reacher?

Also, those do not have a thrust bearing and the companies said the shaft should not take the prop load, so you may wanna help the motor with a thrust bearing it could make for longer life and be smoother.

Flightjunkie · November 13, 2019, 6:13am

Can you post pictures of the rest of the internals of the motor?

Does it have a thrust bearing? And other signs of wear or damage?

Manufoil · November 13, 2019, 6:16am

I tapped a M5 thread in it and it is pretty hard

zaja.cz · December 11, 2019, 2:07pm

You must attach Loctite glue to the inner race of the bearing. Then it would not twist and rub against the shaft. They probably didn’t do it during assembly.

carved · December 15, 2019, 8:46pm

Does anyone of you have a .step file of the maytech motor? Can you share it?

Jsonnett · December 16, 2019, 11:33pm

Here you go. Just modeled this up yesterday after the FlipSky motor which im pretty sure should be identical to Maytech. Download whatever file type you need using the link.

marciopinheiro · December 18, 2019, 2:41pm

Hi. Did you solve your problem? any new firmware from then? Same problem here with Flyer 400A and 100Kv motor…