Flipsky 75200 ESC wiring

[SoEFoil]

Flipsky site: https://flipsky.net/collections/electronic-products/products/flipsky-fsesc75200-75v-high-current-200a-esc-base-on-vesc-with-aluminum-heatsink-for-e-foil-fighting-robot-surfboard-agv-robot-arm

Phase filtering is not available for Flipsky ESC75100 and 75200!
Please turn off the phase filter function and choose "false" in vesc_tool when 
use firmware version on or above 5.3 (VESC_TOOL 3.01). Without turning 
off the phase filter will result in esc damage. Please do not restore the default 
parameters when using the wizard interface.

If you have a simple remote, it should look like this.
My next build will use VESC firmware 5.3 first VESC FW version to allow the use of a magnetic kill switch (normally closed) connected between 7-3.3V and 7-ADC1 set to HIGH in VESC-tool.
Phase filtering disabled on this 75200 version.

Magnet operated kill switch?

all you need is a magnetic hall effect module, power it from the UART port with 3.3v and connect the digital output to the ADC2. Then in the VESC tool go to App Settings, General and under the General Tab you see the last row is labeled kill stitch, and select mode ADC2 High Then when a magnet is near the hall it turn the output to the motor on and when the magnet is taken away it kills the motor