Yes, thats only, so spread the current equal to all 10 cells.
I could have doubled them too, but its 2mm² Nickel, and each cell has direct path to terminal wires, thats ok.
In the middle the Nickel has to take the current from 2 parallel cells, thats the reason i doubled there
I’m really liking the look of this! What is that pink material? I will probably end up building my own board. Any information would be greatfully received.
Its just usual XPS, used for thermal insulation (house basement)
125 * 60 * 14cm
You can get them in various thickness, i was looking for 16cm thickness, but i would have to order a whole pack, so i only got the 14
The thickest part of the board ist now 9,5cm
150cm long, 55cm wide.
Very nice design but why a vertical wall only on the right hand side of the front part ? Rigidity ? It stops water going backward and supposed to cool the motor down.
I was thinking that yesterday when doing the air / water test… it’s time to redesign one
I was about to get the front piece of the rotor out to see that it’s really flush on the inside.
did you measure the power when spinning it in water?
you’re not worried about lack of water circulation?
Get all surfaces as smooooth as possible. Even the stator notches can be filled without thermal worries, just leave a channel open so the wingdings get to water.