MTW-60 Waterproof Connector now online.
Assembly instructions at Printables!
https://www.printables.com/de/model/649814-mt-60-waterproof-connector-mtw-60
5 Likes
The balloon with water test attaching it to the opening. Having difficulty to grasp how it tests waterproofing. Please elaborate.
For the water test, I created special pressure parts to check the tightness. I tested with water in the balloon, with air in the balloon and the pressure part under water.
2 Likes
Right, so you are testing the same printed config+material on a different dedicated for testing part.
Probably you used a setup for waterproofing - like higher temperature, thicker lines, higher temperature?
ASA CF 255°C / 0.1mm and 5 walls / Enclosure 47°C
1 Like
TPU can be used as a seal for my MTW-60 connector.
But with silicone rubber everything makes an even better impression.
Shore of the Silicon A33!
6 Likes
In the last few days things have continued with the second battery.
I also printed the pod for my second motor from XPETG-CF.
4 Likes
impressive printing quality mate! what printer are you using?
1 Like
@okp: Full modded Vyper
Once upon a time there was an Anycubic Vyper. Everything was replaced except the frame.
2 Likes
How do you get those beautiful textured faces on your receiver/batt display? I’m assuming it’s the type/brand of platen?
It’s a 3d printer pei plate
1 Like
Awesome design , pls share the pod file for axis alu on step or f3d file format . I would like to play around with this format . Thanks hips
Thx.
Sorry, I never give out STEP or f3d files.
?why? I always share my steps no publicly but privately
Hello, which charger did you use?[quote=“lishine, post:73, topic:19307”]
Junsi iCharger X12
1 Like
The cables are finished with the MTW-60 connectors.
Everything soldered and filled with epoxy.
First setup, 6384 with FoldProp gives my pump setup. POD to approx. 30-10cm.
Second setup for pure efoil operation with HyperDrive for the 6384.
Third setup, sometime in 63100
with HyperDrive. 
8 Likes
I like the zip ties on the mast trailing edge (*). The set looks ready/mature for mass production 
(*): wonder if there couldn’t be a sharp fairing on the trailing edge to close a proper streamlined profile up attached with the same zip tie.
1 Like
Good morning
where can I find the 18650 battery holders? Thanks again